How to Install Kick Boards for Kitchen Cabinets
- 1). Measure the height and length of the cabinet base area where the toe-kick boards are going with a measuring tape. Write these measurements down with a pencil, on paper. Continue to measure and take note of each cabinet base section where any kick boards will be installed.
- 2). Cut the kick board pieces one-eighth smaller in height than the original measurements to allow for fitting room. Use a hand hacksaw to cut each kick board according to measurements. When using the hacksaw, take care to make clean cuts so if any butting of the kick boards is required, they will fit together cleanly.
- 3). Find matching paint or stain for the kick boards. Go to a paint supply or home improvement store to match the kick-board stain with the existing cabinetry. Remove a small piece of the current cabinetry, such as a small drawer, take this with you when you go to match the stain or paint color. Cabinet drawers should remove easily with a screwdriver. Place these screws into a small plastic bag and set aside for re-installation.
- 4). Prepare the kick board for staining or painting. Use sandpaper to sand the kick boards smooth before applying the stain or paint.
- 5). Dip a paintbrush into the stain or paint and apply it to the kick boards. For staining, allow the stain to sit on the wood for two to three minutes, and wipe off lightly with a cloth rag. Allow each coat of paint to completely dry before proceeding with the next coat. Set the kick boards aside to dry overnight.
- 6). Place the kick boards in the corresponding location under the cabinet base. Hammer finishing nails into the kick boards to secure to the cabinet base. Countersink the finishing nails further into the wood with a nail set.
- 7). Match wood putty to the paint or stain color of the kick boards. Push a tiny amount into each nail hole, and smooth to blend into the kick board.
Source...