How to Wire a Dryer
- 1). Remove the terminal block cover on the back side of the dryer, usually toward the top, with a screwdriver.
- 2). Disconnect the neutral ground wire from the external ground conductor screw. Assemble the neutral ground wire and the neutral white wire from the power supply cord under the neutral terminal block screw and snug the screw down tightly against the terminal block.
- 3). Connect the green ground wire from the power supply cable to the external ground conductor screw and snug the screw down.
- 4). Loosen left and right terminal block screws and connect the two remaining power supply cable wires to these screws and snug the screws down against the terminal block.
- 5). Replace the terminal block cover and tighten the screw.
Source...